Product Overview
The Non-Powered Unwinding Stand is a passive coil-holding and pay-off unit for sheet-metal workshops. It is used with manual folding machines, corrugated-sheet roll-forming equipment and small roofing production lines, providing coil storage at the entry of the material-processing operation.

Key Advantages
Pull-off operation without a reel motor
The coil turns under the pull of the downstream equipment. In a low-speed line where the next machine already controls material advance, the stand supplies the coil without adding a separate electric drive and speed-control cabinet to the pay-off position.
450–550 mm manual bore adjustment
A manual crank adjusts the mandrel across a 450–550 mm expansion range. When changing between coils within that bore range, the operator resets the support diameter mechanically, using the same stand rather than exchanging a fixed-diameter shaft.
Adjustable mechanical drag
A manual friction brake adds resistance to coil rotation. During repeated short pulls or pauses at the next machine, the brake restrains coast-down and limits extra strip payout after the downstream pulling action has stopped.
2,000–5,000 kg support range
A welded H-beam and square-tube frame supports load configurations from 2,000 to 5,000 kg and material widths up to 1,000 mm. Under a full coil, the steel structure provides the stationary support while the reel rotates on its bearings.

Custom Non-Powered Unwinding Stand
The Custom Non-Powered Unwinding Stand is manufactured to suit your available floor area and machine-entry position. Yuanding develops its base and interface dimensions from your layout or technical drawing and applies the specified identification and finish during production.
Customizable Items
• Base length and width
• Mounting-hole arrangement
• Line-entry alignment dimensions
• Paint colour
• OEM branding and nameplate
Key Specifications
|
Parameter |
Value |
| Loading Capacity | 2,000kg - 5,000kg |
| I.D. Expansion | Manual Crank (450mm-550mm) |
| Frame Construction | Welded H-Beam and Square Tube |
| Brake Type | Manual Friction Mechanical Brake |
| Max Material Width | 1000mm |
Quality Control
The incoming inspection checks steel stock and purchased bearings. Machined components and the welded base are inspected before the stand is assembled.
The completed stand undergoes final inspection and an operating trial. Acceptance is completed on the assembled unit before it is prepared for shipment.
Third-party factory inspection is accepted. A full pre-packing inspection is available on request, and production photographs or videos can document the build.
FAQ
Q: How is the stand packaged?
A: The main stand is shipped unboxed with protected working surfaces; small parts can be packed in wooden cases.
Q: Do you provide a sample stand?
A: The stand is supplied as production equipment, rather than as a sample unit.
Q: Can the stand be converted to powered operation?
A: Yuanding can provide technical drawings for a motor retrofit.
Q: Does the stand replace a straightener?
A: No. Flatness correction requires a separate straightener or leveler.
Hot Tags: non-powered unwinding stand, China non-powered unwinding stand manufacturers, suppliers, factory, Bandsaw Feeder, coil forming production equipment, coil loading feeding machine, Heavy Duty Decoiler, Hydraulic Decoiler With Trolley, Strut Type Hydraulic Decoiler
