Product Overview
The Yuanding Roller Shutter Forming Machine produces metal slat profiles for rolling shutters. It is used in door-component factories supplying shopfront shutters, garage closures, warehouse doors and other shutter systems assembled from connected roll-formed slats.

Core Advantages
Staged Forming of Thin Shutter Strip
The line uses 12–22 stations for 0.3–1.0 mm sheet. As the slat face and connecting edges take shape, multiple forming passes divide the required bends along the machine, controlling edge development without forcing the entire thin-wall section through a single forming point.
70 mm Shafts Supporting the Slat Tooling
The forming shafts are 70 mm diameter 45# steel. During continuous runs of narrow shutter strip, these shafts support the paired rolls under repeated bending loads, maintaining the relative working position of the tools that develop the slat body and its edges.
Entry Shearing for Strip Changeover
The infeed combines adjustable guides with a hydraulic front shear. When replacing a coil or preparing a new strip end, the operator cuts at the entry position before threading the next material into the forming sequence, keeping coil preparation separate from final slat cutoff.
Smooth Contact on Pre-Finished Slats
The forming rollers receive heat treatment, precision machining, hard-chrome plating and polishing. With coated shutter stock, the smooth contact faces limit rubbing during repeated passage through the tools, protecting the visible slat surface while the profile's bends are developed.

Custom Roller Shutter Forming Machine
Provide the slat cross-section and its mating-edge detail with the material specification. Yuanding designs the roll sequence and machine layout around the approved shutter profile, then manufactures the forming tools and cutoff for that section.
Customizable Items
•Slat face width
•Slat curvature
•Connecting-edge geometry
•Reinforcement beads
•Feed-strip width
•Coil-loading capacity
•Discharge support arrangement
•Control language and power supply
Key Specifications
|
Parameter |
Details |
|
Material Thickness |
0.3 – 1.0 mm |
|
Forming Stations |
12 – 22 stations |
|
Main Shaft Diameter |
70 mm (45# steel) |
|
Drive Motor Power |
4 – 7.5 KW (Variable frequency) |
|
Blade Material |
Cr12Mov (1,000,000+ cut lifespan) |
|
Control System |
PLC with touch screen (Yaskawa / Schneider) |
|
Factory Location |
Wuxi, China (7,000 ㎡ facility) |
Quality Control
Incoming checks confirm machine-material identity and purchased-component models against the approved build list. Shaft stock, tool stock and structural steel are recorded before machining begins.
The working face of the cutoff blade is hardness-tested after tempering to the HRC 58–62 criterion. The assembled line is checked for hydraulic leakage, wiring conformity and drive operation during its dry run.
Loaded testing verifies the finished slat section and cut ends using representative coil. Actual cut lengths are measured against the production settings, and the trial results form part of the acceptance record released with the machine.
FAQ
Q: How is the equipment packed?
A: The main machine is normally uncrated; small components are packed in wooden boxes.
Q: What is the minimum order quantity?
A: One complete machine.
Q: Is polyurethane foam filling included in roll forming?
A: Foam-filled slats require an additional foam-dosing and curing system.
Q: What is the forming drive power range?
A: 4–7.5 kW, with variable-frequency speed control.
Hot Tags: roller shutter forming machine, China roller shutter forming machine manufacturers, suppliers, factory, Door Frame Forming Machine, Floor Decking Forming Machine, Roller Shutter Forming Machine, Corrugated Sheet Forming Machine, molding main unit, C Purlin Forming Machine