Product Overview
The Yuanding C Purlin Forming Machine converts steel strip into C-shaped structural sections. It is used in purlin production for factory buildings, warehouses and prefabricated steel structures, as well as workshops manufacturing cold-formed support members for storage and building systems.

Core Advantages
Staged Bending for 1.5–3.0 mm Strip
The line's 18–22 forming stations develop the C-section through successive bends. With 1.5–3.0 mm stock, the roll sequence distributes the work needed to raise the flanges and form the section edges, avoiding concentration of the full bending operation at a single stand.
Shaft Support for Structural-Section Loads
The forming-shaft specification ranges from 75 to 100 mm diameter in 45# steel. During repeated production of a structural C-section, the selected shafts support the rolls against the bending load, holding the working relationship between the section's web, flanges and edge-forming passes.
Hydraulic Entry Cut for Coil Separation
The feed section combines adjustable guides with a hydraulic front shear. At coil changeover, the incoming strip is separated at the machine entry before the next coil is threaded, giving the operator a defined preparation point without cutting through a partly formed C-section.
Controlled Drive and Programmed Lengths
A 15 kW variable-frequency motor drives the rolls through a gear-and-chain transmission. PLC length and quantity settings organize repeated member production; when the cut-length schedule changes, the operator updates the program instead of manually marking every structural section.

Custom C Purlin Forming Machine
Provide the C-section drawing, material grade and connection layout. Yuanding develops the roll-pass design and general arrangement from the approved section, then manufactures the forming tools, cutoff and any specified punching equipment as one project.
Customizable Items
•Web depth
•Flange width
•Lip length
•Inside bend radii
•Hole diameter and slot geometry
•Punching positions and sequence
•Coil-loading arrangement
•Control-panel language and site power
Key Specifications
|
Parameter |
Details |
|
Material Thickness |
1.5 – 3.0 mm |
|
Forming Stations |
18 – 22 stations |
|
Main Shaft Diameter |
75 – 100 mm (45# steel) |
|
Drive Motor Power |
15 kW (variable frequency) |
|
Blade Material |
Cr12Mov (1,000,000+ cut lifespan) |
|
Control System |
PLC with touch screen (Yaskawa / Schneider) |
|
Factory Location |
Wuxi, China (7,000 ㎡ facility) |
Quality Control
Incoming material checks verify the machine's steel and tool stock against mill certificates. Purchased drive, hydraulic and control components are checked against the bill of materials before release to assembly.
Cutting tools are hardness-tested after tempering, with Cr12MoV acceptance at HRC 58–62. Frame datums, shaft seats and roll contours are inspected independently of the later finished-section measurements.
Factory acceptance uses representative coil to check the formed section and actual cut length. When a punch unit is included in the order, hole measurements join the same trial record. Dispatch follows acceptance of the loaded run and measurement sheet.
FAQ
Q: Can you provide a purlin sample?
A: Retained trial-run pieces of standard sections are free when available.
Q: What is the minimum order quantity?
A: One complete machine.
Q: Can a C-profile roll set also make a Z purlin?
A: C and Z sections require different forming geometry; C-to-Z capability must be part of the machine design.
Q: Is the C-section cut before or after forming?
A: After forming, by a guided post-shear.
Hot Tags: c purlin forming machine, China c purlin forming machine manufacturers, suppliers, factory, Door Frame Forming Machine, Floor Decking Forming Machine, Roller Shutter Forming Machine, Corrugated Sheet Forming Machine, molding main unit, C Purlin Forming Machine